Genie Industries Z-30/20, Руководство по обслуживанию

Страница: 111 / 150

Part No. 43063 Genie Z-30/20 7 - 1
Service Manual - Third Edition Section 7 - Repair Procedures
Symbols Legend
Indicates the presence of a
hazard that will cause death or
serious injury.
Indicates the presence of a
hazard that may cause death or
serious injury.
Indicates the presence of a
hazard that will or may cause
serious injury or damage to the
machine.
Indicates special operation or
maintenance information.
Indicates that a specific result is expected after
performing a series of steps.
Repair Procedures
About This Section
Most of the procedures in this section should only
be performed by a trained service professional
in a suitably equipped workshop. Select the
appropriate repair procedure after troubleshooting
the problem.
Perform disassembly procedures to the point
where repairs can be completed. Then to
re-assemble, perform the disassembly steps in
reverse order.
General Repair Process
Observe and Obey:
Repair procedures shall be completed by a
person trained and qualified on the repair of
this machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Repairs Start:
Read, understand and obey the safety rules
and operating instructions in the
Genie Z-30/20 Operator's Manual.
Be sure that all necessary tools and parts are
available and ready for use.
Read each procedure completely and adhere to
the instructions. Attempting shortcuts may
produce hazardous conditions.
Unless otherwise specified, perform each repair
procedure with the machine in the following
configuration:
· Machine parked on a flat, level surface
· Boom in the stowed position
· Turntable rotated with the boom between
the non-steering wheels
· Key switch in the
OFF
position with the key
removed
· Battery packs disconnected
· Wheels chocked
Malfunction
discovered Identify
symptoms
Troubleshoot
Perform
repair
Return to
service
problem
solved
problem
still exists
Inspect
and test