Genie CCTV Rapport mini, Руководство пользователя

Страница: 9 / 20

MODE
MODE
MODE
제품소개
FAR
OPEN
TELE
OSD
NEAR
CLOSE
WIDE
MODE SET
MODE
SET
PWR
CHG
Tx
Rx
MODE
SET
PWR
CHG
Tx
Rx
RAPPORT-MINI Ver : 0.03
[ Mode change ]
• Video Tester (Color CCTV Field Monitor )
• Color Bar Generator (Standard Video Signal Generator)
• Digital Multimeter
• PTZ Controller
• Receive Data Analyser
• Setup
• Torch ON / OFF
FAR
OPEN
TELE
OSD
NEAR
CLOSE
WIDE
MODE SET
VIDEO NTSC
BRI 3
CON
7
METER VIDEO PTZ DATA SETUP
COLOR
0101
Functional use
Power ON/OFF
The power switch is located on the side of the handset.
Turn the power switch on, and press to start Rapport mini.
To turn off the system, press & hold for more than 2 sec. Then,
POWER OFF is displayed on the main screen with a beep. Release the
button. Turn the power switch OFF to prevent battery drain during storage.
The switch must remain ON to recharge the batteries.
A rechargeable battery should be plugged in over 5 hours to fully charge.
The charged battery can operate for about 8 hours.
When the battery indicator shows below , recharge it for use. (Full
charge: )
FUNCTIONAL SPECIFICATION
FUNCTIONAL SPECIFICATION
After the power is applied the above on-screen message is displayed.
Approximately 2 seconds later the screen switches to the last OSD before power
was turned off. The Rapport mini stores the last accessed OSD.
The initial OSD message displays the Rapport mini's firmware information. Versions of the
product change whenever new firmware is uploaded.
Mode setup
Main Functions
The MODE SELECT menu is displayed when the key is depressed and
moves to the next menu whenever the key is pressed
The OSD menu changes whenever the key is pressed, and sequences
through in the following order :
VIDEO -> ColorBar -> Meter -> PTZ controller -> Receive Data -> SETUP
->VIDEO
SET
SET
16 MULTI FUNCTION CCTV TESTER 17 MULTI FUNCTION CCTV TESTER