1.
Insert the SDHC card.
2.
Assemble the Genie HD AutoView main body and bracket.
3.
Decide where best to position the product on the windscreen
-
ideally
behind the rear view mirror. Clean up humidity moisture and dirt from the
windscreen using a clean, dry lint free cloth.
4.
Remove the protective film covering the adhesive tape of the bracket.
5.
After attaching the bracket to the windscreen, tighten the bracket screw
using a coin or small screwdriver.
6.
Connect the power cable and secure with cable ties.
7.
Start driving and use the product (the REC LED light is ON during normal
operation).
8.
Turn OFF HD AutoView and remove the SDHC. Check the recorded data
using the viewer software on a PC.
Easy Installation
Caution
Only install the product when the vehicle is stationary
First connect the product to the power outlet then turn it on..
Only use the supplied power cable (DC12~24V).
Clean the windscreen where the product is to be attached. Dirt and
moisture could make the product fall from the windscreen.
