GENEVO PRO II, Руководство пользователя и инструкция по установке

Страница: 7 / 9

12 13
A) GENEVO PRO II CONTROL UNIT
The Control Unit is usually placed in a fuse
box, or in a space above pedals, using a strip-
ping tape, or double-sided sticky tape. For
connecting individual components follow the
markings on the control box. All can be easily
done thanks to plug-in connectors. When
connecting individual accessories please
mind the plug you are trying to connect the
cables into, as they must be connected to a
correct plug, in case it isn’t the system might
not work properly or be permanently dam-
aged. Also, be mindful of placing the control
unit so that the speaker on top of it is placed
facing in free space.
B) DISPLAY
The display is usually placed in the vehicle
cabin on your consideration using dou-
ble-sided sticky tapes, or magnetic tape. We
recommend placing the display in an easily
accessible area.
C) GPS ANTENNA
Secure the GPS antenna with a suitable seal-
ant or double-sided adhesive tape to ensure
directing the antenna at the sky. We recom-
mend positioning it on the dashboard of the
vehicle. If you place the GPS antenna under
the instrument panel, the antenna must
not be overshadowed by metal elements
(beware of metal-plated and heated wind-
shields). you can check the antenna’s func-
tionality on the display. If the GPS icon glows
constantly, it means it works as intended, in
case it’s blinking it means that it can not find
a GPS signal. It can take up to 12 minutes for
the first time to fix the GPS signal.
D) SPEAKER
The signaling speaker should be placed
somewhere in the leg-space of the driver, or
passenger. Select the location of the speaker
so that the alerts can be heard clearly.
E) RADAR ANTENNA HD+ / HDM+
The radar antenna is highly sensitive equipment
that can detect multiple types of police radar sig-
nals. The correct installation is crucial to its proper
functionality and good sensitivity of the detector.
The antenna is mounted to the front of the car,
usually behind its plastic bumper or behind the
front grille in front of the vehicle radiator. It must be
installed in the place from where the front part has
a good view of the road ahead. It is ideal to locate
the antenna into the bumper vent, 30-50 cm above
the ground. If you choose to mount the antenna so
that the bumper covers its front part, check the ma-
terial from which the bumper is made and whether
it contains a metal reinforcement. Some types of
plastic can weaken radar waves and reduce the ef-
ficiency of the detector. Never mount the antenna
behind metal parts of the vehicle! When installing
the antenna, you can use self-tapping screws
in places where the nut can be attached from
the other side, as well as classic nut bolts. After
selecting a suitable location for the antenna and
the type of screws, drill two to four screw holes. It
is recommended that the antenna is attached with
4 screws. The antenna cable can be slightly bent.
Firstly, attach the antenna with two screws cross-
wise against each other and tighten them partly,
then mount the remaining two screws. In some
vehicles, it is advisable to carry out the installation
using a special support plate that is included in the
packaging. It has the shape of the letter “L” and is
made of a thick steel plate with pre-drilled holes.
Firstly, screw the support plate to the appropriate
place, and then attach the antenna to the plate. In
addition, keep the antenna as far away as possible
from heat sources such as the engine radiator and
air conditioner from which the antenna may heat
up. Failure to observe a sufficient distance will not
guarantee proper operation and may cause the
antenna to overheat due to increased temperature.
F) LASER SYSTEM CONTROL UNIT
The laser system control unit is installed in the in-
terior of the vehicle, either under the dashboard or
someplace similar to the GENEVO PRO control unit.