• All plumbing and electrical work should be performed by an accredited professional to ensure all
federal, state, local and municipal regulations are met.
• Do not use the system with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• When there is moderate to high turbidity, a filter should be installed before the water softening
system on the inlet side.
• If the water pressure exceeds 120psi, a pressure reducing valve must be installed before the
water inlet. If the water pressure exceeds 80 psi, installing a pressure reducing valve before the
water inlet is highly recommended. If the water pressure is under 20 psi, a booster pump must
be
installed before the water inlet.
• Replacement parts for the Genesis 2 AIO valve should only be purchased through Discount Water
Softeners resellers. Electrical
transformers are
specific to the Genesis 2 AIO valve from Discount
Water Softeners.
• Regular interval monitoring of the water quality and work environment is recommended to
ensure proper operation of the valve system.
• Any modifications the Discount Water Softeners equipment, which is outside the standard scop
e
of supply, voids the product warranty.
• Discount Water Softeners equipment, like all modern electronic devices, can be damaged by
electrical surges or brown outs. Every effort has been taken to harden the circuits, by design, to
protect against such events. These precautions, or even additional surge protection, are not
100
%
effective. Therefore, equipment damage caused by abnormal electrical events is not
covered by warranty.
• Complete system must be protected from outdoor elements such as rain, moisture and direct
sunlight. Failure to do so voids warranty.
***Failure to use this product within the described conditions may void the warranty***
Pre-Installation Check List
Before installation, read through this manual thoroughly. Then obtain all materials and tools needed for installation.
This system will operate at maximum efficiency when the following conditions are considered.
Required
Genesis 2 AIO
Operation Conditions:
Working Conditions
Working pressure
20psi - 120psi
Water temperature
35 °F - 125 °F
Working Environment
Environment temperature
35 °F - 125 °F
Relative humidity
≤95%
Power source
100 - 240VAC 50/60Hz
Inlet Water Quality
Turbidity
2FTU
Chlorine
Iron
2+
0.1 mg/l
or less
7
mg/l
M
A
X
/
Iron
3
+
6
