Genesis GDP805P, Руководство оператора

Страница: 4 / 40

English
8” 5-Speed Drill Press
Operator’s Manual GDP805P
•
Do not use a tool if the switch does not turn it on or off.
Any tool that cannot be
controlled with the switch is dangerous and must be repaired or replaced by an authorized service center
.
•
Turn the power tool off, and disconnect the plug
from the power source and/or battery
pack from the power tool before making any adjustments, changing the accessories, or storing the tools
.
Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury .
•
Store the idle tool out of reach of children and other inexperienced persons
.
It is dangerous in the hand of untrained users.
•
Maintain power tools with care.
Check for proper alignment and binding of moving parts,
components, and any other conditions that may affect the tool’s operation. A guard or any other part that is
damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal injury.
•
Use recommended accessories.
using accessories and attachments not recommended by the
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator’s manual for recommended accessories.
•
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control .
•
Feed the work piece in the correct direction and speed.
feed the work piece into a
blade, cutter, or abrasive surface against the direction of the cutting tool’s direction of rotation only. Incorrectly
feeding the work piece in the same direction may cause the work piece to be thrown out at high speed.
•
Never leave the tool running unattended, turn the power off.
Do not leave the tool
until it comes to a complete stop.
•
Never start the power tool when any rotating component is in contact with
the work piece.
WArNING:
USE OF THIS TOOL CAN GENErATE AND DISBUrSE DUST Or
OTHEr AIrBOrNE PArTICLES, INCLUDING WOOD DUST, CrYSTALLINE SILICA
DUST AND ASBESTOS. Direct particles away from face and body. Always operate
tool in a well-ventilated area and provide for proper dust removal. Use dust collection
system wherever possible. Exposure to the dust may cause serious and permanent
respiratory or other injury, including silicosis (a serious lung disease), cancer, and
death. Avoid breathing the dust, and avoid prolonged contact with the dust. Allowing
dust to get into your mouth or eyes, or lay on your skin may promote absorption of
harmful material. Always use properly fitting NIOSH/OSHA approved respiratory
protection appropriate for dust exposure, and wash exposed areas with soap and
water.
SERVICE
•
Have Your Power Tool Serviced by a qualified repair person using only
identical replacement parts
. This will ensure that the safety of the power tool is maintained.
•
Service Your Power Tool periodically.
When cleaning a tool, be careful not to disassemble any
portion of the tool since internal wires may be misplaced or pinched.
SAVE THESE INSTRUCTIONS
EXTENSION COrDS
Grounded tools require a three wire extension cord.
Double insulated tools can use either a
two or three wire extension cord. As the distance from the power supply outlet increases, you must use a heavier
gauge extension cord. using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord can
carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total length,
be sure each cord contains at least the minimum wire size required. If you are using one extension cord for more
than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.