Genesis 11c EFORCE 2.0, Руководство пользователя

Страница: 45 / 65

45
CUTTING (CUTTERS, COMBINATION DEVICES)
To prevent the blades from being damaged, they must always be placed at right angles
to the material to be cut.
Also, the tips of the blades must not be more than 5 mm apart during the cutting
process. If this value is exceeded, the cutting process must be stopped and then
started again.
CAUTION!
Do not sever any parts with loose ends, because
this can result in personal injury due to parts flying
off.
ATTENTION!
When cutting high-strength vehicle body parts, such as shock
absorbers, hinges or steering columns, the shear blades (arms) may
cause severe damage.
Lifting / pressing (Rams)
In its closed state, the rescue cylinder is positioned for lifting or pushing away vehicle
body parts. Therefore, make sure that the cylinder is placed as centrally as possible
and at a right angle to the load.
For better positioning, the pushing head can be turned on the piston rod.
Suspended parts must immediately be suitably braced and supported. It is forbidden
to stay under suspended loads.
NOTE!
Before the rescue cylinder is used, the attachment point must be
supported so that force develops in the desired direction.