Generic XOR 125, Руководство по обслуживанию

Страница: 13 / 97

12
AIR CLEANER
Clean every 3000KM
If the air cleaner is clogged with dust, intake resistance will, be increased with a resultant decrease in power output
and an increase in fuel consumption. Check and clean the element in the following manner.
Remove screw 1 and screw 2 ， take down air cleaner
Unscrew tapping screw 3 ， remove air cleaner cap 4
Fill a washing pan of a proper size with Non-flammable cleaning solvent.
Immerse the air Cleaner in the cleaning solvent and wash them clean.
Squeeze the cleaning solvent out of the washed element
By pressing it between the palms of both hands: do not twist
or wring the air cleaner filter core element or it will develop tears.
，
Immerse cleaned filter core of air cleaner in CCI or CCI SUPER oil, and
squeeze the oil out of the core
，
which may be slightly wet with oil.
Install air cleaner filter core in the reverse order of removal.
CAUTION
：
‹ Before and during the cleaning operation, inspect the core for tears. A
tore core must be replaced
‹ Be sure to position the filter core, so that no incoming air will bypass it.
Remember, rapid wear of piston rings and cylinder bore is ofter caused by
defective or poorly fitted filter core.
А Non-flammable cleaning solvent
Б CCI or CCI SUPER oil
THROTTLE CABLE
Adjust every 1000KM.
Loosen locknut
，
and adjust throttle cable play by turning adjuster in or out to obtain the following cable play. After
adjusting the calbe play
，
tighten the locknut.
Cable play ： 0.5-1.0MM （ 0.02.-0.040 inch ）
Engine idle speed
Adjust every 1000KM.
•
Adjust the throttle cable play.
•
warm up the engine.
Note
：
Warm up engine for 10 minutes.
Connect an electric tachometer to the connecting protion of the
magneto lead wire as shown in the illustration. Use the selector key “C’
position.
2
4
1
3