MAJOR COMPONENTS
Description
The Electronic Air Cleaner is approximately 29½ x 27
x 14½ inches (75 x 68.6 x 37 cm). The unit is designed to
be mounted to the ceiling. The steel cover and intake grill
are hinged to allow easy access to the collecting cells
and power box. The unit is rated up to 1300 CFM (2210
m
3
/hr).
Cabinet
The cabinet is constructed of 20 gauge steel. The
external parts have a tough powder-coated, scratch-
resistant finish. The internal parts are galvanized steel.
Access to the collecting cells, power box and prefilters is
made by lifting the cover, sliding towards the front and
lowering.
The cover is interlocked to cut power to the unit when
opened.
Prefilters
The washable prefilters measuring 12½ x 20 inches
(31.75 x 50.8 cm) are constructed of multi-layers of
aluminum mesh for maximum filtration of large particles.
Collecting Cells
The dual voltage collecting cells are constructed of
heavy gauge aluminum to resist rust and damage. The
first stage, the ionizing section, is charged at
approximately 7500 VDC. The collecting plates are
alternately grounded and charged at 5000 VDC. The
arrow on the cell indicates the direction of air flow which
must point up towards the fan motor.
Motor & Fan Blade
The motor is 1/12 HP, 1050 RPM, 3 speed, controlled
by a 3-position slide switch. The motor is thermally
protected. The fan blade is aluminum, 18 inches (45.7
cm) with a 16
˚ pitch.
INSTALLATION
1. Read instructions carefully. Failure to do so may
result in product damage or injury.
2. Make sure the sizing is correct for your application.
3. Installation should be done by a knowledgeable
technician.
4. After installation, check out operation as provided in
these instructions.
Mounting
1. Remove the unit from the box with packing still on the
unit and lay it on its back, grill side up.
2. Release the cover by sliding towards the front of the
unit and lifting up.
3. Remove the "S" hook from each chain, tilt cover up,
and release from back.
4. Remove the cells and prefilters from the unit before
installing.
5. Holes are provided in the cabinet to accommodate
5/16 inch (8 mm) threaded rod. Threaded rod can be
attached to angle iron, laid across the joists, and
drilling holes through these supports. Pass threaded
rod up through the supports and secure with two nuts
and washers. This will allow adjustment of the unit so
that it is flush with the underside of the ceiling.
Leave enough room around the Air Cleaner for
removal of collecting cells and prefilters.
6. Replace the cells, prefilters and cover. Hook up the
safety chain to the cover.
Do not hang the unit with chain only. This will not
3
Fig. 2
—
Coanda Air Flow
The
Air
Cleaner
creates a circular air
flow
pattern
which
never allows air to
rest at the ceiling.
Blower
and
Motor
are
hidden behind 4 directional
discharge air grills.
Rear Hinge permit smooth
release of cover for easy
installation.
3-Speed Fan Control allows
adjustment of air flow to
activity level in room.
Hinged
Cover
provides
convenient access to Grill,
Prefilters
and
Collecting
Cells. Safety interlock cuts
power
when
cover
is
opened.
Heavy duty Collecting Cells
( 2 )
c a p t u r e
a i r b o r n e
pollutants and simply wash
clean.
Washable, aluminum mesh
Prefilters (2) catch lint and
large particles before they
enter collecting cells.
Removable Intake Grill for
easy cleaning.
Fig. 3
—
Components
