FCS10 RIP-R-STRIPPER
®
FLOOR COVERING STRIPPER
FORM GOM26110801US, VERSION 1.0
English-EN
8
REMOVING RIP-R-STRIPPER FROM CARTON
1.
Open carton and carefully separate product components from packing
materials.
NOTE:
Operator handle loop is located under top thin, grey layer of packing
film and nested inside the central, top cushioned pack. DVD, nuts, bolts,
blades and T-Handle Hex Key are located in corner pack cavity.
ASSEMBLING, INSTALLING & REMOVING OPERATOR HANDLE
Assembly and installation of operator handle will require a level work surface of
appropriate size and height.
Tools Required:
1 each,1/2 inch (12.7 mm) Hex combination wrench or ratchet with socket.
1.
Set main frame assembly on work surface making sure all wheels and
blade clamp/debris fence area are in contact with surface.
2.
Loosen operator handle locking knob until it hits outer stop point. DO
NOT attempt to force locking knob beyond this point or to remove
completely. FIGURE 4.
FIGURE 4
3.
Slide bottom end of operator handle assembly under handle locking knob
of main frame with center slot wrapping around threaded shaft. At same
time, engage raised, fixed bolt heads of main frame in keyhole slots.
Press down and slide handle assemble toward locking knob until audible
click is heard. FIGURE 5
FIGURE 5
IMPORTANT:
Fixed bolt heads should now be fully engaged at top of keyhole
slots and handle lock button, located in top corner of mounting plate, will
protrude and be visible through hole in plate. FIGURE 5
4.
Hand tighten operator handle locking knob to fully secure operator handle
shaft assembly to main frame.
5.
Attach operator handle loop to upper end of handle shaft assembly using
two bolts and hex nuts provided. Position/nest handle loop over top of
mounting shafts located on both sides of handle assembly with loop
toward back of unit where operator would stand. FIGURE 6
FIGURE 6
IMPORTANT:
Ensure handle loop ends fully engage/nest over mounting
shafts and underside of bolt heads sit flush and fully engage/nest over top of
handle loop ends. FIGURE 7
FIGURE 7
6.
Determine RIP-R-STRIPPER ON/OFF switch is in OFF position and unit
is not connected to power source.
7.
Connect power head power cord to power cord located at switch end of
operator handle assembly. Twist to lock to prevent separation. FIGURE 8
WARNING
•
Installing operator handle loop positioned (away) from
operator location and not properly securing will decrease
machine control and productivity.
•
Improper handle loop position and/or inadvertent shifting
and/or separation of handle loop section can result in
property damage and/or personal injury.
CAUTION
•
Wear appropriate safety glasses and other appropriate
safety apparel when opening and removing product from
carton and setting machine up for operation.
•
Improper protection can result in property damage and/or
personal injury.
WARNING
•
Operator handle assembly must be fully engaged and
secured in position to main frame.
•
Improper assembly to main frame can result in property
damage and/or personal injury.
WARNING
•
Unexpected machine start-up can result in property
damage and/or personal injury.
