FCS10 RIP-R-STRIPPER
®
FLOOR COVERING STRIPPER
FORM GOM26110801US, VERSION 1.0
English-EN
12
10 OPERATING INSTRUCTIONS
IMPORTANT:
DO NOT operate RIP-R-STRIPPER until each operator
completely comprehends contents of this manual.
RIP-R-
STRIPPER SET-UP ON JOBSITE
1.
Position RIP-R-STRIPPER on a suitable work surface.
2.
Determine RIP-R-STRIPPER ON/OFF switch is in OFF position and unit
is not connected to power source. FIGURE 18
FIGURE 18
3.
Install operator handle assembly to main frame per STEPS 1 thru 4 in
ASSEMBLING, INSTALLING & REMOVING OPERATOR HANDLE
section within MACHINE SET-UP section of this manual.
4.
Install accessory blade per procedures in INSTALLING & REMOVING
ACCESSORY BLADES in MACHINE SET-UP section of this manual.
5.
Lock power head ON/OFF switch into ON position by placing index finger
on bottom side, front portion, of switch then rock up and toward bottom of
operator handle until it locks in place. FIGURE 19
FIGURE 19
NOTE:
To release power head switch to OFF position, simply press upward on
back portion of switch and release. Front portion of switch will unlock and
become fully exposed.
6.
Connect extension cord to main power cord of RIP-R-STRIPPER.
FIGURE 20
FIGURE 20
7.
Connect additional extension cord to remaining end of first extension cord
(if applicable).
IMPORTANT:
If additional extension cords are required, each cord must be of
proper structural integrity and size (AWG) to meet applicable National Electric
Code and OSHA requirements. An additional extension cord with integral GFI
can be used in conjunction with RIP-R-STRIPPER which also has an integral
GFI.
WARNING
•
If operating RIP-R-STRIPPER in outside environment, use
only extension cords marked “W-A” or “W”.
•
Such cords are rated for outside usage and reduce risk of
electric shock.
WARNING
•
Unexpected machine start-up can result in property
damage and/or personal injury.
WARNING
•
Floor covering removal process can produce excessive
noise, vibration and flying debris.
•
All operators and work personnel in RIP-R-STRIPPER
vicinity must wear appropriate safety eye wear and
hearing protection.
•
Other safety apparel and/or procedures, deemed
necessary by supervisory personnel, must also be worn
and/or practiced by all appropriate personnel.
CAUTION
•
Individual operator experience, skill, common sense, job site
location and specific job application will affect final decision on
specific operating procedures for RIP-R-STRIPPER.
•
Each operator must decide if he possesses adequate/proper
experience, skill and common sense for operating Hole Digger
in any given and/or specific job application.
CAUTION
•
If RIP-R-STRIPPER and/or an individual component/
accessory does not appear to function properly, STOP
and DO NOT operate RIP-R-STRIPPER until corrective
action has been completed.
•
Operation with improperly functioning machine,
components/accessories can result in property damage
and/or personal injury.
•
If you have any questions regarding proper operation of
RIP-R-STRIPPER, contact Customer Service Department
for assistance BEFORE using. There is no charge for this
service.
WARNING
•
Do not modify or replace any extension cord component
without utilizing a factory approved component only.
WARNING
•
All electrical wiring including extension cord gauge and/or
length must be installed and/or approved in accordance
with local electrical codes and practices.
•
An improper wiring installation can result in property
damage and/or personal injury.
