SAFETY INSTRUCTIONS
CAUTION!
The meter’s targeting laser is a Class 2M type that emits less
than 1 mW of radiation at 660 nanometers.
Avoid direct eye contact with the laser, and do not point it at
people or animals. Eye protection is normally afforded by the
blink reflex. U.S. law prohibits pointing a laser beam at aircraft;
doing so is punishable by a fine of up to $10,000 and
imprisonment.
SETUP INSTRUCTIONS
INSTALL BATTERIES
The LDM60 is ready to use after you install the two supplied
“AAA” batteries in a compartment in the back of the meter. To
open the compartment, use the small supplied Phillips-head
screwdriver to loosen the single screw holding the battery
compartment cover in place. Remove the cover and set it aside.
Position the batteries so their polarity marks match the diagram
inside the compartment. Replace the cover and tighten the screw
to secure it.
OPERATING INSTRUCTIONS
POWERING ON AND OFF
To turn the meter on
, press and release the
button. This
activates the display and the laser. It also sounds a short beep,
causes the laser icon (Callout 2 of Fig. 2) to flash, and places the
meter in direct distance measurement mode.
MEAS
10
