General Monitors TA402A, Инструкция по эксплуатации

Страница: 24 / 51

Setup Check & Setup Modes (
con tin ued
)
ENTERING THE INHIBIT MODE
n
This option applies to the Setup Mode
only:
If the password option is disabled,
or after the correct password has been
entered, the display will indicate
In
for
five seconds (figure 15). Pressing the
Mode/Select switch while
In
is
displayed, will cause the unit to enter the
Inhibit mode by inhibiting the alarm
outputs. After the Model TA402A has
entered the Inhibit mode, pressing the
Mode/Select switch causes the unit to
return to normal operation (see section
5.3). If it is desired to enter the Setup
Mode, do not press the Mode/Select
switch for the five seconds
In is
displayed.
Fig ure 15
A2 ALARM OPTIONS
n After the Inhibit mode option, the
A2
LED on the front panel will be flashing
while the Energized/De-energized option
is displayed (figure 16). The display will
indicate the current selection, (
En
or
dE
). Press the Mode/Select switch until
the desired option is displayed.
De-Energized is the factory default for
this selection.
Fig ure 16
n The A2 LED on the front panel will
be flashing while the
latching/non-latching option is displayed
(figure 17). The display will indicate the
current selection, (
nL
or
LA
). Press the
Mode/Select switch until the desired
option is displayed. Latching is the
factory default for this selection.
Fig ure 17
20
User Interfaces
General Monitors