General Monitors TA402A, Инструкция по эксплуатации

Страница: 22 / 51

18
User Interfaces
General Monitors
Setup Check & Setup Modes (
continued
)
This section is provided to aid the operator in making selections during the Setup Mode. It is
recommended that the operator fill in the selections in the proper blanks and then use this page
as a reference while programming the TA402A. The blocks shown below indicate the order of
options in the Setup Mode. To the right of each block is a description of the choice(s) that are
available. More information about making each selection is provided in the pages that follow.
Pass word En ter the Pass word, if the Pass word is en abled.
In hibit
Mode
En ter the In hibit Mode, if de sired.
EN TER SE LEC TION
A2 Alarm
Op tions
Set the En er gized (En) / De- Energized (dE) Op tion
Set the Latch ing (LA) / Non- Latching (nL) Op tion
Set the Time De lay (1, 2, 4, or 8 sec onds)
A1 Alarm
Op tions
Set the En er gized (En) / De- Energized (dE) Op tion
Set the Latch ing (LA) / Non- Latching (nL) Op tion
Fault/In hibit
Op tion
Set the Fault Ac ti vate (Ac) or not (nA) dur ing In hibit Op tion
Card Test
Op tions
Dis play will in di cate “ct” for 5 sec onds
Set the Alarm out puts for Ac tive (Ac) or Not Ac tive (nA)
Pass word
Op tions
Set the Pass word to be Dis abled (Pd) or En abled (PE)
If the Pass word is En abled:
Set the pass word dig its . . . . . . . . Left Right
Setup Check
Mode
Af ter all of the op tions have been se lected, the TA402A will en ter the Setup Check
Mode.