S4000C
8
To connect wiring to the Screw Type terminal block, (Figure 7) use a screwdriver to loosen the
top screw counter clock wise. Insert the wire into the terminal and tighten the top screw clock
wise. Check the hold of the wire by GENTLY tugging it to ensure it is locked in.
Figure 6: Spring Type Terminal Block Operation
Figure 7: Screw Type Terminal Block Operation
Figure 8: Wire Strip Length
NOTE:
Up to 12 AWG wire can be used if it is carefully stripped (on a Screw Type terminal)
(Figure 6).
3.5.3 DC Power and Ground Connections
The customer must provide primary DC power unless one of the following General Monitors
Modules is being used with the Model S4000C:
•
DC130 Dual-Channel Readout/Relay Display Module
•
TA102A Trip Amplifier Module with a PS002 Power Supply & Relay Module
