General International MS3008, Руководство по установке и эксплуатации

Страница: 9 / 26

ENGLISH
9
v.200915
ASSEMBLY
REMOVE ALL THE PARTS FROM THE BOX
Your Sliding Compound Miter Saw is fully assembled in the carton with the
exception of some small accessories.
Check to ensure everything you need is included:
● 2 extensions- one for each side
● Hold-down clamp assembly
● Dust bag
● 2 AA batteries.
WARNING! Always disconnect the tool from power source before
making any adjustments, storing, servicing, or changing accessories.
Such preventive safety measures reduce the risk of starting the tool
accidentally.
● Unlock the saw from its various storage and shipping positions.
● To disengage the cutting head from its shipping and storage position,
push down lightly on it and pull out the spring-loaded cutting head lock
knob on the right side shown at U, fig.3. Turn it a quarter turn until the
pin in the shaft rests in the small groove to hold the button out.
● Ensure the miter setting handle, table lateral extensions, hold-down
clamp, and dust bag are properly attached.
MITER SETTING HANDLE
Insert the miter setting handle (W, fig.4) into the miter table, screwing it in
clockwise until tight.
● The handle can be loosened and used as a lever to move the miter
table to any angle from 45° left to 45° right and then turned clockwise to
tighten it at any desired angle.
● The miter angle lock lever must be disengaged while moving it from
side to side to prevent the angle from stopping at the detent points.
TABLE EXTENSIONS
Two side extension/carrying handles (D, fig.1) are included with your saw
to help support longer pieces of material.
● Each fits into two holes on the left or right side of the saw table and is
fastened with a set screw.
● The two extensions have adjustable extension tables fitted on them
and can be slid into the saw base for more compact storage or can be
extended to widen the supported area.
1. Install the side extension/carrying handles (D, fig.1), sliding each one,
with the end curved and table
upward, into the double holes
at the left and right sides of the
table. The extensions must be
fastened in place by tightening
the extension retention set
screw (E2, fig.1) recessed into
the top of the table bed.
2. Attach the rubber foot
pads onto the feet of the saw
base.
HOLD-DOWN CLAMP
ASSEMBLY:
1. The hold down clamp
(C, fig.1) included can be
installed in either of the two
holes positioned just behind
the fence at both the left and
right ends (C6, fig.5).Slide the
shaft (C4, fig.5) into the hole
and then tighten the hold-down
clamp retention screw (C7,
fig.5). Grooves around the
shaft allow the screw to hold
fig.4
X W
C3
C6
C7
fig.5
C1
C3
C2
C4
C5
C6