General International MS3008, Руководство по установке и эксплуатации

Страница: 17 / 26

ENGLISH
17
v.200915
MAINTENANCE
MOUNTING AND REMOVING THE
BLADE
WARNING:
Before replacing the saw blade always unplug the tool.
Make sure that the spindle speed diameter and saw blade bore match.
Only use sharp and undamaged saw blades. Cracked or bent saw
blades must be replaced immediately.
1. Unplug the saw from the outlet.
2. Raise the miter saw to the upright position. Slide the cutting head
assembly completely toward the rear of the unit and tighten the sliding
carriage lock knob (G, fig.1).
3. Raise the lower blade guard (T, fig.1&2) to the uppermost position.
4. While holding the lower blade guard, loosen but do not remove the
cover plate screw (M1, fig.22) with a Phillips screwdriver by turning the
screw counterclockwise.
5. Rotate the cover plate (M2, fig.22) back to expose the arbor bolt (4).
6. Lower the cutting head and lock into place with the cutting head lock
knob (U, fig.3).
7. Place the blade wrench over the arbor bolt (4)
8.
Locate the arbor lock (S, fig.2) below motor lower cover.
9. Press the arbor lock, holding it in firmly while turning the blade
clockwise. At a certain point the arbor lock will engage and lock
the arbor. Continue to hold the arbor lock, while turning the wrench
clockwise to loosen the arbor bolt (4, fig.23).
10. Unlock cutting head and raise head to upright position.
11.
Remove the arbor bolt (4, fig.23).
NOTE:
This bolt has a left hand thread.
To remove it, you must turn it clockwise .
12. Remove the outer blade collar (6), and the blade (7, fig.23).
13. Do not remove the inner blade collar (9, fig.23).
NOTE:
Pay attention to the pieces removed, noting their position and
direction they face. Wipe the blade collars clean of any sawdust before
installing a new blade.
14. Clean the bolt, washer, inner and outer flanges.
15. Place a new saw blade with the teeth pointing in the direction of rotation
onto the inner flange and saw blade shaft. (See the arrow on the upper
blade guard).
16. Place the outer flange on the saw blade shaft.
17. Engage the lock knob, mount the washer and blade bolt. Tighten it by
turning it counter-clockwise.
18. Lower the saw blade guard.
fig.22
M
T
M1 M2
fig.23
6
9
7
4
8