General International MS3008, Руководство по установке и эксплуатации

Страница: 21 / 26

ENGLISH
21
v.200915
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE - SAW OPERATION
PROBLEM PROBLEM CAUSE
SUGGESTED CORRECTIVE
ACTION
Blade hits table. 1. Misalignment. 1. See ADJUSTMENT- CUTTING
ARM TRAVEL section.
Angle of cut not
accurate. Can not
adjust miter.
1. Miter table unlocked.
2. Sawdust under table.
1. See OPERATION - MITER
ANGLE ADJUSTMENT section.
2. Vacuum or blow out dust. WEAR
EYE PROTECTION.
Cutting arm
wobbles.
1. Loose pivot points. 1. Contact Service Center.
Cutting arm will
not fully raise, or
blade guard
won’t fully close.
1. Pivot spring not
replaced properly
after service.
2. Sawdust build-up.
1. Clean and lubricate moving parts.
2. Contact Service Center.
Blade binds,
jams, burns
wood.
1. Improper operation.
2. Dull or warped blade.
3. Improper blade size.
4 Wood is moving
during cut.
1. See BASIC SAW OPERATION
section.
2. Replace or sharpen blade.
3. Replace with 12 in. diameter
blade.
4. Use clamp to secure workpiece
to fence unit and table.
Saw vibrates or
shakes.
1. Saw blade not round /
damaged / loose.
2. Arbor bolt loose.
1. Replace blade.
2. Tighten arbor bolt.