General International MS3005, Руководство по установке и эксплуатации

Страница: 15 / 36

English
15
150323
ADJUSTMENT OF BEVEL ANGLE
1. at the rear of the saw, on the right side of where the arm pivots is a hex
socket head depth setting screw that limits the 45° bevel.
2. Loosen the locking nut and adjust the screw with a 5 mm hex key to
adjust the stop point to be correct at 45 degrees of bevel.
3. Check the settings with a square against the blade.
4. re-tighten the locking nut once the angles are correct.
Once the bevel is correct, the bevel degree indicator at the back can be
adjusted to indicate the exact angle in the following way:
1. Loosen the cross head screw and re-set the indicator to read exactly 0
degrees when the vertical stop is contacted.
2. re-tighten the screw.
PREVENTIVE MAINTENANCE
Keep your tool in good condition by adopting a regular maintenance
program.
WARNING: Prior to inspection or saw maintenance, turn off power
switch and disconnect plug from power source.
● Before each use, examine the general condition of your tool.
● Inspect blades, switches, tool cord and extension cord for damage.
● Check for loose screws, misalignment, binding of moving parts,
improper mounting, broken parts, and any other condition that may
affect its’ safe operation.
● If abnormal noise or vibration occurs, turn the tool off immediately and
have the problem corrected before further use.
● Do not use a damaged tool.
● Never disassemble the tool or try to do any rewiring on the tool’s
electrical system.
● Keep the vents clear of dust and debris. this will help prevent possible
electrical shorts and ensure proper cooling.
● Keep the tool housing and handle clean and free of oil and grease
using mild soap and a damp (not wet) cloth. use only mild soap
and damp cloth to clean your tool since certain cleaning agents and
solvents are harmful to plastics and other insulated parts. some of
these harmful solvents include: gasoline, turpentine, lacquer thinner,
paint thinner, chlorinated cleaning solvents, ammonia, and household
detergents containing ammonia.
● the table kerf plate inserts should be replaced if damaged to reduce
the risk of chips lodging in the slot and catching in the blade.
● If the tool is to be stored for any length of time, remove the batteries
from the laser battery compartment to prevent damage to the device.
● Lubrication is done at the factory and with the exception of the slide
bearings, should not be necessary again under normal use.
● an authorized repair center should do any repairs, modification, or
maintenance that involve disassembling the saw.
● any damage to the tool should be corrected at an authorized repair
center. Contact General International for all repairs.
wARNING!
Never use flammable or combustible solvents
around tools.
wARNING!
To reduce the risk of injury, electric shock and damage to
the tool, never immerse your tool in liquid or allow liquid to flow
inside the tool.