INSTALLATION OF THE FRONT AND REAR MOUNTING BRACKETS
TO THE BANDSAW’S TABLE
Note: The M6 bolts, washers, lock washers and hex nuts required for this step are provided with your Excalibur® Universal
Bandsaw Rip Fence System. However, if they do not fit into the mounting holes on your table, use the fasteners provided
with your original fence.
1. The image above shows the positioning of the
mounting brackets when properly installed to the
table (front and rear brackets are installed at oppo-
site sides of the table).
INSTALLATION OF THE FRONT AND REAR RAILS
Note: The front rail is the wider one of the two rails.
1. Install a 5/16" screw
, a flat washer
, and a
square nut
on both front mounting brackets.
2. Install a 5/16" x 5/8" lock knob
and a square nut
on both rear mounting brackets.
8
a. Bolt
b. Washer
c. Mounting
bracket
d. Table
e. Washer
f.
Lock washer
g. Hex nut
ORDER OF
ASSEMBLY
2. Place the bolts, washers, lock washers and hex nuts
as shown above to attach the mounting brackets
(front and rear) to the table. Don’t tighten the nuts
yet.
3.
Insert the square nut
of the first front mounting
bracket into the T-slot of the front rail
.
4. Then, slide the rail onto the second square nut
.
