1.
Do not operate the bandsaw when tired, distract-
ed, or under the effects of drugs, alcohol or any
medication that impairs reflexes or alertness.
2.
The working area should be well lit, clean and free
of debris.
3.
Keep children and visitors at a safe distance when
the bandsaw is in operation; do not permit them to
operate the bandsaw.
4.
Childproof and tamper proof your shop and all
machinery with locks, master electrical switches
and switch keys, to prevent unauthorized or unsu-
pervised use.
5.
Stay alert! Give your work your undivided attention.
Even a momentary distraction can lead to serious
injury.
6.
Fine particulate dust is a carcinogen that can be
hazardous to health. Work in a well ventilated area
and use a dust collector whenever possible. Wear
protective hair covering to contain long hair and
wear non-slip footwear, approved safety glasses,
dust mask and hearing protection.
7.
Do not wear loose clothing, gloves, bracelets, neck
laces or other jewelry while the bandsaw is in ope-
ration.
8.
Be sure that adjusting wrenches, tools, drinks and
other clutter are removed from the machine and/or
the table surface before operating.
9.
Keep hands well away from blades and all moving
parts. Use a brush, not hands, to clear away chips
and dust.
10. Adjust and position upper and lower blade guides
before starting to cut. Upper blade guide should be
adjusted to approximately 1/8” above the material
to be cut.
11. Adjust blade tension and tracking before starting to
cut.
12. Saw teeth must point down toward the table.
13. Be sure that the blade has gained full operating
speed before starting to cut.
14. Always use a clean, properly sharpened blade.
Dirty or dull blades are unsafe and can lead to
accidents.
15. Use suitable work piece support if the work piece
does not have a flat surface.
16. Hold material firmly against the table.
17. Do not work on long stock without adequate sup-
port on the out feed end of the table.
18. If using a power feeder, stop the feeder before stop-
ping the bandsaw.
19. Do not push or force stock into the blade. The band-
saw will perform better and more safely when work-
ing at the rate for which it was designed.
20. Avoid working from awkward or off balance posi-
tions. Do not overreach and keep both feet on floor.
21. Keep guards in place and in working order. If a
guard must be removed for maintenance or
cleaning, be sure it is properly re-attached before
using the tool again.
22. Never leave the machine unattended while it is run-
ning or with the power on.
23. Use of parts and accessories NOT recommended
by General
®
International may result in equip-
ment malfunction or risk of injury.
24. Never stand on machinery. Serious injury could
result if the tool is tipped over or if the cutting tool is
unintentionally contacted.
25. Always disconnect the tool from the power source
before changing accessories such as blades, or
before performing any maintenance or cleaning,
or if the machine will be left unattended.
26. Make sure that the switch is in the “OFF” position
before plugging in the power cord.
27. Make sure the tool is properly grounded. If
equipped with a 3-prong plug it should be used
with a three-pole receptacle. Never remove the
third prong.
28. Do not use this bandsaw rip fence for other than its
intended use. If used for other purposes, General
®
International disclaims any real implied warranty
and holds itself harmless for any injury, which may
result from that use.
Rules for Safe Operation
To help ensure safe operation, please take a moment to learn the machine’s applications and limita-
tions, as well as potential hazards. General® International disclaims any real or implied warranty and
hold itself harmless for any injury that may result from the improper use of its equipment.
5
