ENGLISH
19
141110
WARNING!
When cutting metal, the area of the cut may be sharp and
can cause damage to property and self. Be extremely careful when
handling.
CUTTING IN VERTICAL ORIENTATION
1. Identify and mark the cutting path on the work piece.
2. Remove the switch lock screw by unscrewing the safety nut.
3. Pull out the switch safety screw.
4. Flip the switch up to the ON position.
5. Place the work piece on the vertical cutting plate.
6. Allow the band saw to reach full speed before making any cuts.
WARNING!
Keep hands clear of blade at all times.
7. With one hand on each side of work piece, slowly guide the work piece
into the blade (fig 39).
NOTE:
Do not apply excessive pressure. Forcing the blade through
your work piece puts unnecessary strain on the motor. Too much
force will likely produce unwanted cut quality and will wear the blade
prematurely.
8. After the cut has been made, turn off the band saw.
9. Replace the switch safety screw and safety nut.
MAINTENANCE
WARNING!
Always disconnect the tool from power source before
making any adjustments, storing, servicing, or changing accessories.
Such preventative safety measures reduce the risk of starting the tool
accidentally.
CHANGING THE BLADE
1.
Raise the band saw head to the vertical position (fig 40).
.
2.
Locate the support plate (X, fig 40) at the base of the band saw near the
motor.
3. Rotate the support plate clockwise to help prevent the band saw head
from falling. (See also fig 32)
4.
Locate the switch tab (R, fig 40).
5.
Locate the M6 x 12 cross head screw (s, fig 40) holding the switch tab.
6. Remove the screw and the switch tab.
7.
Locate the plum screw (p, fig 33 & 40) and remove it, turning it counter-
clockwise.
8. Open the blade back cover.
9.
Locate the upper blade cover (DD, fig 40).
10. Locate the two M6 x 12 cross head screws that hold it in place.
11. Unscrew these 2 screws and remove the upper blade cover by pulling
down on it.
12.
Locate the lower blade guard (FF, fig 41) and the two 2 M6 x12 cross
head screws (cs, fig 41
)
13. Unscrew the two screws from the blade guard and remove it.
Содержание BS5205
Страница 50: ...FRANÇAIS 50 ...