INSTALL THE EXALIBUR FENCE SYSTEM
This bandsaw is supplied with an Excalibur Deluxe Bandsaw
Rip Fence System.
Follow all assembly and adjustment instructions in the 90-075A
manual supplied in the box with the Rip Fence System.
For added convenience, two lock knobs with square nuts
A
are supplied with this bandsaw in replacement of the
5/16” screws, flat washers and square nuts supplied with
the fence system for front rail installation.
3.
Attach the push handle to the push handle bracket
as shown using the two wing nuts
A
already
mount- ed on the push handle bracket.
1.
Thread the handle
A
on the blade guard adjust-
ment handwheel as shown in
B
.
2.
Firmly tighten the handle using the supplied 12 mm
wrench.
A
B
C
C
C
D
Loosely attach the 3 supplied screws and nuts
A
to the wooden fence as shown in
B
. Install the wooden fence on
the right face of the rip fence by sliding the nut of the 3 screw/nut assemblies
C
in the T-slot on the right face of the
rip fence
D
. Using a screwdriver, tighten the screws to secure the wooden fence against the rip fence.
INSTALL THE HANDLE ON THE BLADE GUARD HEIGHT ADJUST-
MENT HANDWHEEL
INSTALL THE PUSH HANDLE
An auxiliary wooden fence is also supplied for enhanced workpiece support when working with taller stock. Install
the auxiliary wooden fence as follows:
A
BASIC ADJUSTMENTS AND CONTROLS
MAGNETIC SAFETY SWITCH
This bandsaw is equipped with a magnetic safety switch
located on the control panel
A
at the front of the machi-
ne. This magnetic switch is designed to protect the unit
and the user from power surges, power outages and
un-wanted or unintentional start-up.
The switch assembly is equipped with a green “ON” but-
ton
B
and a RED spring loaded “STOP” button
C
. Once
the RED “STOP” button has been pressed, the machine
can only be started by turning the RED button to the
right to release the stop button.
B
C
A
11
A
B
CONTROL PANEL
A
