1.
Remove the red insert
A
from the center of the
table and the table alignment pin
B
from the table
slot.
ATTACHING THE TABLE
C
C
D
E
2.
Turn the table right side up. Verify that the long
bolts
C
in the center of each trunnion are pointing
down the holes in the table-tilt bracket.
3.
Carefully move the table into position over the
table-tilt bracket, guiding the saw blade through
the table slot
D.
4.
Rotate the table 1/4 turn counter-clockwise so that
the saw blade is now perpendicular to the table
slot
E
.
C
F
5.
Gently lower the table onto the bracket so the
long bolts
C
in the center of the trunnions pass
through the holes in the table-tilt bracket.
Note: If the long bolts have moved out of position, have an
assistant tap them into place with a screw driver.
6.
Thread the two lock knobs
F
onto the long bolts
now protruding from the underside of the table-
tilt bracket and tighten loosely.
I
J
8.
Re-install the red insert to the center of the table,
with the opening in the slot facing the rear of the
saw
K
.
9.
Re-install the table alignment pin into the table
slot
L
.
K
L
A
B
7.
Make sure that the blade
F
is centered in the table
opening
G
. If the blade is not centered, slide the
table back or forward until the blade is centered
in the table opening. Then tighten the six combi-
nation head bolts
H
using a 10 mm wrench and
the two hex bolts
I
and
J
using a 12 mm open
wrench and 12 mm socket wrench.
12
F
H
G
H
