19
MAINTENANCE
CLEANING
For optimum performance from your machine follow this maintenance schedule and refer to any specific instruc-
tions given in this section. After using your machine, sweep up and discard any excess metal chips and debris.
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
REGULAR MAINTENANCE TASK FREQUENCY
DAILY
WEEKLY
MONTHLY
2 x YEAR
• Basic cleaning of the
machine
• Fill the coolant tank if
necessary
• Inspect the blade
• Leave the saw head
in the ”up” position
to reduce tension on
the return spring
• Check the splash
guards and verify
that the emergency
stop works properly
• Thoroughly clean the
machine, including
the tank and filter
• Clean and grease the
vise screw and the
slides
•
Clean the blade holder
• Make sure all the fast-
eners are tightened
• Inspect the condition of
all guards
• Grease the saw head
pivot shaft
• Change the gear
box oil
CHANGING THE GEAR BOX OIL
1
. Position the saw head in the down position. Re-
move oil plug
A
with an18 mm wrench to drain the
gear box. Once the used oil is drained, re-install the
plug
A
.
Note: To avoid damage do not overtighten the plastic plug A.
2
. Remove the downfeed handle using a wrench to
access the filling hole.
3.
Fill the gear box with 1,5 liters of 460 grade gear
oil
.
Re-install the downfeed handle (see section ”In-
stalling the downfeed handle”).
A
