14
SWITCH OFF
TO AVOID UNEXPECTED OR UNIN-
TENTIONAL START-UP, MAKE SURE
THAT THE POWER SWITCH IS IN
THE OFF POSITION BEFORE CON-
NECTING TO A POWER SOURCE.
BASIC ADJUSTMENTS & CONTROLS
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG. RE-
PLACE DAMAGED CORD OR PLUG IMMEDIATELY. TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP, MAKE SURE
THE POWER SWITCH IS IN THE OFF POSITION BEFORE CONNECTING TO A POWER SOURCE.
CONNECTING TO A POWER SOURCE
Once the assembly steps have been completed, plug
the power cord into an appropriate outlet.
Refer back to the section entitled ”Electrical Require-
ments” and make sure all requirements and grounding
instructions are followed.
When cutting operations have been completed, un-
plug the saw from the power source.
MAGNETIC SWITCH
This machine is equipped with a magnetic safety switch
designed to protect the unit and the user from power
surges, power outages or unintentional start-up.
The switch assembly is equipped with a green ”start”
button
A
, a red ”stop” button
B
and a emergency stop
button with twist lock-out device
C
. Once this button has
been pressed, the machine can only be restarted by
turning the button to the right to release the stop but-
ton,
E
.
The coolant system pump is controlled using switch
D.
To start the pump, turn the switch to the right. To stop the
pump, turn the switch to the left.
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE ”OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
1.
Screw the handle into the mounting hole on the
vise handwheel
2.
Tighten the handle using a 12 mm wrench.
INSTALLING THE VISE HANDLE
C
D
A
B
E
