General International 50-057, Руководство по установке и эксплуатации

Страница: 8 / 24

XI. INSTALL A SAW BLADE
1. Remove the table insert by pulling with your finger
in the hole,
. Use the supplied arbor wrench, ,
turning it counter-clockwise to remove the arbor nut
and flange,
.
2. Install a saw blade (not supplied with the saw) so
that the openings between the teeth face the front of
the saw
(the blade spins in the counter-clockwise direction).
3. Replace the flange and arbor nut. Wedge a board
between the saw teeth at the back of the saw,
, so
the blade won’t turn as you tighten the nut clockwise
with the arbor wrench.
Remove a saw blade: wedge a block of wood between
the teeth in front of the saw and turn the arbor wrench
toward you, or counter-clockwise.
XII. INSTALL TAPE MEASURE ON FRONT RAIL
1. Raise the blade 1”- 2” above the table, move the fence to lightly touch the right side of the blade and lock the
fence in place ,
.
2. Using a pencil, make a light reference line on the top of the rail in-line with the screw hole for the fence
pointer,
.
3. Remove the fence and stick the right hand (long) adhesive tape measure to the rail, roughly lining the zero point
on the tape with your reference line on the rail,
.
4. To Install the left hand tape, repeat the same steps but to the left of the blade.
Install the pointer on the fence either to the left or left as needed. Do not fully
tighten the pointer screw just yet. With the fence locked in place against the blade,
line the reference line up on the pointer with the zero point on the tape and now
tighten the pointer screw.
Note: when changing blades re-align the pointer with the zero point on the tape, to account
for thinner or thicker blade widths.
Be sure the saw is disconnected from the power
source whenever installing or removing a saw
blade!
8