General International 50-057, Руководство по установке и эксплуатации

Страница: 4 / 24

10” DELUXE BUILDER’S TABLE SAW
50-075 (right tilt)
A S S E M B L Y I N S T R U C T I O N S
ASSEMBLY TOOLS PROVIDED ADDITIONAL TOOLS NEEDED
• Arbor blade guard bracket wrench • Straightedge
•12 mm combination wrench • Large slot and large Phillips screwdrivers
• Two Allen wrenches • Socket wrench (recommended) and Adjustable wrench
I. ASSEMBLE THE STAND
1. With the 32 carriage bolts, washers and hex nuts,
, begin assembling one end of the saw stand by
attaching 1 short top shelf and 1 short tie bar to 2
legs,
.
Do not tighten hex nuts until all fasteners are atta-
ched. Then place the stand on a flat surface to
square it up and finally tighten all the nuts.
2. Assemble the opposite side of the stand the same way
as described in step 1. Then use the 2 long top shelves
and 2 long tie bars to join both assembled ends and
complete the stand as shown in the photo below.
3. Fasten tool hook, , to front (use one screw) or either
long top shelf (use both screws) of stand. Fasten
brackets,
- (for stowing miter gauge and fence
when not in use) to long sides of stand.
4. Attach the 4 rubber feet to saw stand using 2 hex nuts
and 2 washers After fully assembled saw is placed in its
final location, level the feet by loosening top nut,
,
adjusting lower nut up or down on the screw stem as
needed, then tightening down the top nut.
If you will be using the mobile base (50-025), do not attach
rubber feet. Fasten the stand directly to the mobile base.
4
Short top shelf
Legs
Short tie bar
(Be sure to attach all horizon-
tal shelves and tie bars to the
insides of stand legs.)