General International 40-350, Руководство пользователя

Страница: 4 / 23

inspected
before shipment and if properly used will give perfect results, However, a reasonable
amount of care and attention is necessary to ensure perfect performance and accurate
work. It is imperative that you take a few moments to familiarize yourself with these
instructions, as they will no doubt save you a lot of
UNPACKING AND CLEANUP
and install it accurately before use. As soon as you receive
the shaper, we recommend you follow these procedures:
1. Finish removing the contents of the shipping wooden case and compare with the
contents list.
3. Clean all rust protected surfaces with a mild solvent or kerosene. Do not use lacquer
thinner; paint thinner, or gasoline. These will damage painted surfaces. -
4. To prevent rust, apply a light coating of paste wax to surface.
INSTALLATION
1. Machine must be placed on a flat, solid surface.
2. Remove all foot bolts locking it to its shipping base before lifting machine.
4. Test machine length-wise and cross-wise before starting any operations.
5. Metal shims must be placed under low corners.
6. Once all four corners are supported, tighten lag screw, and retest machine in both
directions.
POWER CONNECTIONS
The spindle shaper has been factory wired before shipment. Before connecting to the
power source, verify that power outlet corresponds with the motor voltage. All electrical
and motor wiring must be performed by a qualified electrician. This machine must be
properly grounded while in use for protection against electrical shock.
ELECTRICAL CONTROLS
button, magnetic control system, and
a reverse switch.(Fig. 1,2)
A
B
C
FIG.1