General International 30-460, Инструкция по эксплуатации и перечень запасных частей

Страница: 7 / 38

TABLE ROLLS (Fig.17)
The planer is equipped with two-table rolls (A); which aid in feeding the
stock. This will reduce friction between the stock and the table and will
rotate as the stock is fed through the planer.
1.
To raise the table rolls, loosen lock lever (B) as illustrated in Fig.17
and pull control lever (C) upwards to the required height setting.
2. To lower the table rolls, loosen locking lever (B) and push the
control lever (C) downwards to the required height setting.
3.
After adjusting height of the table roll, tighten the lock lever (C) in
order to lock in position.
CHECKING AND ADJUSTING TABLE ROLL HEIGHT
It is not possible to give the exact dimensions on the proper height
setting of the table rolls because each type of wood has different
behavioral patterns. As a general rule, when planing rough stock,
the table rolls should be set high (.003» to .005») above the table
surface. When planing finish stock, the table rolls should be set low
(.001») above or level with the table surface.
To verify and adjust the height of the table rolls, proceed as follows:
1.
Disconnect the machine from the power source.
2.
With the table rolls in the lowest position, place a straight edge (A)
Fig.18, across both table rolls (B) or the left side of the table as
shown.
3. With a feeler gauge (B) Fig.19, measure the gap between the
table surface and the straight edge (A) near the infeed roll (C).
4. If adjustment to the infeed table roll is necessary, loosen the lock-
nut (D) Fig.20; located under the table and below the infeed roll and
rotate adjustment nuts (E) as required to raise or lower the height of
the infeed roll.
NOTE: it will be necessary to raise the table in order to gain access to
the adjustment nuts. Tighten locknut (D) after adjustment is made.
5. Verify and adjust the height of the infeed table roll or the other
side of the table in the same manner.
6. To check the height of the outfeed table roll, proceed as follows:
with a feeler gauge (B) Fig.21, measure the gap between the table
surface and the straight edge (a) near the outfeed roll(F).
F
FIG. 17
FIG. 18
FIG. 19
FIG. 21
7
FIG. 20