General Equipment RIP-R-STRIPPER FCS10GEN2, Руководство оператора

Страница: 13 / 27

FCS10GEN2 RIP-R-STRIPPER ® FLOOR COVERING STRIPPER
FORM GOM03042001US, VERSION 1.2
English-EN 12
FIGURE 17
3. Install operator handle assembly to main frame per STEPS 1 thru 6 in
INSTALLING & REMOVING OPERATOR HANDLE section within
MACHINE SET-UP section of this manual.
4. Install accessory blade per procedures in INSTALLING & REMOVING
ACCESSORY BLADES in MACHINE SET-UP section of this manual.
5. Lock power head ON/OFF switch into ON position by placing index finger
on bottom side, front portion, of switch then rock up and toward bottom of
operator handle until it locks in place. FIGURE 18
FIGURE 18
NOTE: To release power head switch to OFF position, simply press upward on
back portion of switch and release. Front portion of switch will unlock and
become fully exposed.
6. Connect extension cord to main power cord of RIP-R-STRIPPER.
FIGURE 19
FIGURE 19
7. Connect additional extension cord to remaining end of first extension cord
(if applicable).
IMPORTANT: If additional extension cords are required, each cord must be of
proper structural integrity and size (AWG) to meet applicable National Electric
Code and OSHA requirements. An additional extension cord with integral GFI
can be used in conjunction with RIP-R-STRIPPER which also has an integral
GFI.
WARNING
•
For maximum protection against a fault, if used, always
configure GFI to be plugged into power source
receptacle.
•
Configurations with GFI placed between RIP-R-STRIPPER
and power source will not provide maximum protection
against potential fault.
WARNING
• If operating RIP-R-STRIPPER in outside environment, use
only extension cords marked “W-A” or “W”.
•
Such cords are rated for outside usage and reduce risk of
electric shock.
DANGER
•
DO NOT operate RIP-R-STRIPPER without extension
cords/GFI in proper operating condition. The GFI is
intended as a safety device in event power source has a
fault.
• Always assume electrical wiring on every jobsite can
contain a fault.
• A fault can generate a dangerous operating configuration
that can result in property damage and/or personal injury.
WARNING
• Unexpected machine start-up can result in property
damage and/or personal injury.
WARNING
• DO NOT modify or replace any extension cord component
without utilizing a factory approved component only.
WARNING
• All electrical wiring including extension cord gauge and/or
length must be installed and/or approved in accordance
with local electrical codes and practices.
• An improper wiring installation can result in property
damage and/or personal injury.
WARNING
• Keep power and extension cords free and clear of
machine and blade.
• In event extension cord becomes entangled about RIP-R-
STRIPPER and/or operator turn machine OFF
immediately.
•
Determine extension cords/GFI are in proper condition to
continue operation.
•
In event of damage, replace with factory approved
component only and/or products meeting applicable
National Electric Code and OSHA requirements.
WARNING
•
DO NOT abuse the power cord. Never use power cord to
move RIP-R-STRIPPER or pull plug from receptacle.
Damage to cord can result.
•
Keep cord away from heat, oil, sharp edges (including
accessory tool) or moving parts.
• A damaged cord increases the risk of an electric shock.