General Equipment EP8HL, Руководство оператора

Страница: 12 / 53

EP8HL HAZARDOUS BLOWER
FORM GOM7069501, VERSION 1.2
10
Assembly
MODEL EP8HL HAZARDOUS LOCATION,
PORTABLE, AIR VENTILATION BLOWER.
Open the shipping carton immediately upon receipt.
Visually inspect the contents of the carton for freight
damage and/or missing parts. If shipping damage is
evident, contact the delivering carrier to arrange for an
inspection of the damage by their claims
representative. If missing parts are detected, notify
your dealer who will assist you in obtaining them.
Included in the shipment should be the following:
1 each, Blower
1 each, lifting handle
1 each, bag of assorted hardware
1 each, Operator's Manual and related educational
material
INSTALLING THE RUBBER MOUNTS TO THE
FRAME.
Tools Required: 2 each, 7/16 inch wrenches
The EP8HL Blower is shipped from the factory secured
to a plywood base. The base provides support and
additional structural integrity for the Blower during
transit. Before placing the Blower into service, proceed
to remove it from the plywood base.
DO NOT OPERATE THE BLOWER WITH THE
PLYWOOD BASE CONNECTED TO THE FRAME.
SECURING THE BLOWER TO THE BASE
REQUIRES THE USE OF STEEL FASTENERS. DO
NOT OPERATE THE BLOWER WITH THE STEEL
FASTENERS SECURING THE RUBBER MOUNTS
TO THE FRAME. THESE FASTENERS CAN
CREATE A RANDOM SPARK WHICH CAN BE THE
IGNITION SOURCE OF AN EXPLOSION. SUCH AN
OCCURRENCE CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
1) Using the wrenches, remove the steel fasteners
from the frame. Properly discard these fasteners by a
suitable method to prevent their accidental use on the
Blower. No steel fasteners are permitted to be utilized
in open, exposed areas of the Blower.
2) Open the plastic bag containing the four (4) 1/4 inch
diameter x 1 inch long aluminum capscrews and
related hardware.
3) Install an aluminum capscrew into the recess area
provided on the rubber mount. The head of the
aluminum capscrew will thrust against the metal
support washer of the rubber mount.
4) Install the lockwasher and aluminum hexagon nut.
Using the wrenches, secure the assembly to the frame
until snug. Do not over torque the aluminum fasteners.
Damage to the fasteners can result. FIGURE 1.
FIGURE 1
5) Repeat the process for the remaining rubber
mounts.
6) In the event that an aluminum capscrew and
hexagon nut becomes damaged while installing a
rubber mount, replacement hardware is provided. If
these replacements are not required, discard by a
suitable method.
I NSTALLING THE LIFTING HANDLE.
Tools Required: 1 each, 1/2 inch wrench
1) Install the lifting handle to the studs provided on the
blower housing. Secure tight with the provided lock
washers and hexagon nuts. Do not over torque the
aluminum fasteners. Damage to the fasteners can
result. FIGURE 2.