2.4M SERIES 1241 ANTENNA
4096-859
ASSEMBLY MANUAL
REVISION A
Prodelin Corporation
Page 20
8/17/2012
Figure 11: Complete Reflector
STEP 7
(A) Install Quad #1 and Quad #4 using the same procedures as outlined in STEP 6. After all the
seam bolts are installed, begin tightening the 5/16” seam bolts from the center out until all the
seam bolts are tightened to the recommended torque. (See table 1)
Note:
Make sure the Reflector brackets (items 7, 8, 9, 10, 11), and the cross arm (item 13),
are fully seated against the reflector support with no gaps between any of the components
before completing the next procedure.
(B) Next tighten the 3/8” cross arm and center bracket hardware to the recommended torque.
(See table 1)
(C) To complete the reflector assembly, tighten the four reflector insert nuts and the four 1/2"
reflector bolts to the recommended torque. (See table 1)
5/16” Seam Bolts
1
2
4
3
3/8” Cross Arm
Hardware
1/2" Reflector
Bolts
Shown with 1240
series positioner for
illustration only
