Generac Power Systems G0071020, Инструкция

Страница: 2 / 12

Oil Filter Heater Kit 2
Figure 2. Removing Customer Connection Panel Cover
(2013–2015 Units)
Installing the Oil Filter Heater
(9kW Models)
1. Drain engine oil and remove oil filter.
2. See Figure 3 . Install new oil filter and tighten by hand until
seal contacts sealing surface. Then, hand-tighten oil filter
an additional full turn. Slide oil filter heater (A) over the oil
filter as shown, with the connector plug at the bottom.
Figure 3. Installing the Oil Filter Heater (9 kW)
3. Plug the connector into one of the Y-harness sockets (B).
4. See Figure 4 . Pass the lead wires and empty Y-harness
socket beneath the engine and through the harness
grommet (C) in the engine divider panel,
Figure 4. Routing Heater Wires (9 kW)
5. See Figure 5 . Pass the lead wires through the customer
connection panel grommet (D). If the empty Y-harness
socket (E) will not be connected to a battery heater, coil the
wires and secure with a plastic wire tie. Secure all wires with
plastic wire ties at least 0.5 in. (1 cm) away from fuel hoses.
Figure 5. Lead Wires to Customer Connection (9 kW)
6. Proceed to Connecting Lead Wires .
Installing the Oil Filter Heater
(11-22kW Models)
1. Drain engine oil and remove oil filter.
2. See Figure 6 . Install new oil filter and tighten by hand until
seal contacts sealing surface. Then, hand-tighten oil filter
an additional full turn. Slide oil filter heater (A) over the oil
filter as shown, with the connector plug at the bottom.
Installing the Oil Filter Heater (11-22kW)
Figure 6. Installing the Oil Filter Heater (11-22 kW)
3. Plug the connector into one of the Y-harness sockets (B).
4. See Figure 7 . Pass the lead wires and empty Y-harness
socket beneath the engine and through the harness
grommet (C) in the engine divider panel,
002916
A
002774
A
B
002775
C
002776
D
E
002779
A
B