Generac Portable Products 2,400 PSI High Pressure Washer
6
• Insert the carriage hook through the left hole (facing the
front of the unit). Pull the recoil handle out of the engine
slowly. Place the recoil string through the hook and
attach the plastic knob. Tighten by hand (Figure 2).
• Insert the carriage bolt through the right hole (facing the
front of the unit) and attach a plastic knob. Tighten by
hand (Figure 2).
• Insert the wire support with the longer arm positioned
on the left. From the rear of unit, the hook should
resemble a “J” (Figure 3).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended oil
to engine.
NOTE: Check Oil Often During Engine Break–in.
Add Gasoline
DANGER!
Never fill fuel tank indoors. Never fill
fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
• Use fresh, clean unleaded automotive gasoline and store
in approved, clean, covered containers. Use clean fill
funnels. Never use “stale” gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add “UNLEADED” regular gasoline to fuel tank.
Use a funnel to prevent spillage. Slowly fill tank to about
1/2” below the bottom of the filler neck (Figure 4).
• Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.
• Uncoil the high pressure hose and attach one end of the
hose to the base of the spray gun (Figure 5). Tighten by
hand.
Figure 2 — Secure Handle
Figure 4 — Add Gasoline to Fuel Tank.
Figure 3 — Attach Wire Form to Handle
