Generac Portable Products 2,400 PSI High Pressure Washer
10
• Twisting the nozzle adjusts the spray pattern from a
narrow pattern to a fan pattern Figure 14).
• Point the nozzle down toward a hard surface and press
the trigger to test the pattern (Figure 15).
• For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning surface.
• If you get the spray nozzle too close, especially using high
pressure mode, you may damage the surface being
cleaned.
• Do Not get closer than 6 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
IMPORTANT: You must attach all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump.
To apply detergent, follow these steps:
• Review the use of the adjustable nozzle.
• Prepare detergent solution as required by the job.
• Hang the detergent solution on the hook of the
wireform attached to the handle.
• Place the small filter end of the detergent siphoning tube
into the detergent container (Figure 16).
CAUTION!
Keep the detergent siphoning tube
from coming in contact with the hot muffler. This
will damage the plastic tube. When inserting the
filter into a cleaning solution bottle, route the tube
so as to keep it from inadvertently contacting the
hot muffler.
• Make sure the garden hose is connected to the water
inlet. Check that the high pressure hose is connected to
the spray gun and the pump.
• Start the engine, then attach the nozzle extension.
• Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle in
high pressure position.
Figure 16 — Insert Filter into Container.
Twist nozzle
counterclockwise for fan
spray pattern.
Twist nozzle clockwise
for narrow spray
pattern.
Figure 14 - Adjusting Nozzle Spray Pattern
Figure 15 — Test the Spray Pattern.
