Generac Portable Products 2200 PSI High Pressure Washer
8
Attach the other end of the high pressure hose to
the high pressure outlet on the pump (Figure 5).
Tighten by hand.
Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (Figure 6). Clean the
screen if it contains debris or have it replaced if
damaged. DO NOT RUN THE PRESSURE
WASHER IF THE SCREEN IS DAMAGED.
Run water through your garden hose for 30
seconds to clean out any debris .
Connect the garden hose to the water inlet. Tighten
by hand (Figure 6).
Turn ON the water.
Squeeze the trigger on the gun to purge the pump
system of air and impurities.
CAUTION:
Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
Attach the nozzle extension to the spray gun.
Tighten by hand (Figure 7).
CHECKLIST BEFORE
STARTING ENGINE
Review the assembly to ensure you have performed
all of the following.
Check for properly tightened hose connections
(high pressure and water supply) and for tight
connections and that there are no kinks, cuts, or
damage to the high pressure hose.
Check that oil has been added to the proper level
in the engine crankcase before trying to start the
pressure washer.
Add the proper gasoline to fuel tank.
Provide a proper water supply (not to exceed
140°F).
Be sure to read the Safety Rules and Operation
sections before using the pressure washer.
Figure 6 Connect the Garden Hose to Water Inlet
and Turn ON the Water.
Inspect inlet
screen, do not use
if damaged, clean
if dirty.
Figure 7 Connect Nozzle Extension to Spray Gun
Figure 5 Connect High Pressure Hose to Pump
Connect high
pressure hose here.
