Introduction
Congratulations and a thank-you for the purchase of this Genelec
SE7261A DSP Subwoofer. This manual addresses setting up
and using the Genelec SE7261A DSP Subwoofer with Genelec
810A digital input loudspeakers in stand-alone mode without the
GLM.SE™ software and the proprietary Genelec loudspeaker
control network. Use with the GLM.SE™ network is described in
the GLM.SE™ System Operating Manual.
EC Declaration Of Conformity
This is to certify that Genelec SE7261A DSP Subwoofer conforms
to the following standards:
Safety: EN 60065: 2002 / IEC 60065:2001 7th Edition
EMC: EN 5501:2001 + A1:200
EN 55020:2002 + A1:200
EN 61000--2:2000 + A2:2005
EN 61000--:1995 + A1:2001
The products herewith comply with the requirements of The Low
Voltage Directive 7/2/EEC, EMC Directive 2004/108/EC
Signed:
Ilpo Martikainen
Position:
Chairman of the Board
Date:
20-September-2007
Compliance to FCC Rules
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment under FCC
rules.
System
Genelec SE7261A DSP Subwoofer is designed for precise
monitoring of 24 bit/192 kHz AES/EBU digital audio signal. It is
fully compatible with Genelec GLM.SE™ Loudspeaker Manager
Software and the proprietary Genelec loudspeaker control
network and Genelec 810A digital input loudspeakers.
The SE7261A can perform bass management. The DSP
bass management system splits the signal from each input into
low and high frequency components. Signal content below the
crossover frequency is reproduced by the subwoofer and signal
content above the crossover frequency is reproduced by the
loudspeakers connected to the outputs of the subwoofer.
Using the SE7261A in
Stand-Alone Mode
When the subwoofer is not connected to the Genelec loudspeaker
control network, it operates in stand-alone mode and only the
functions actuated by the controls on the connector panel can be
used. However, the settings made with the GLM.SE™ software
can be saved into the subwoofer and applied even when the
Содержание SE7261A
Страница 1: ...SE7261A DSP Subwoofer Operating Manual ...
Страница 2: ... ...
