performance of the monitors. An extension
of three years for the guarantee period can
be obtained by registering the product on
the Genelec website. Refer to supplier for
full sales and guarantee terms.
Accessories
A wide selection of accessories is
available for Genelec monitors. Consult the
Accessories Catalogue on www.genelec.
com or your local distributor/dealer for
up-to-date information.
Compliance to FCC Rules
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
Note: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced
radio/TV technician for help.
Modifications not expressly approved by
the manufacturer could void the user’s
authority to operate the equipment under
FCC rules.
Button press
Function
Notes
Short press
Power on, power off
Long press
Enter special mode, exit
special mode
Press longer than 5 seconds
Special mode: one short
press
Mode 1: AES/EBU channel
A selected, room-related
calibration in use
Power button light blinks
once every few seconds
Short press advances
Mode 2: AES/EBU channel
B selected, room-related
calibration in use
Power button light blinks
twice every few seconds
Short press advances
Mode 3: AES/EBU channel
A selected, factory calibra-
tion in use
Power button light blinks
three times every few
seconds
Short press advances
Mode 4: AES/EBU channel
B selected, factory calibra-
tion in use
Power button blinks four
times every few seconds
Special selection: long
press
Once a special mode 1-4
has been selected, a long
press selects the special
mode
Press longer than 5 sec-
onds; the RAM-L selects
the special mode and starts
playing. To exit the special
mode turn off the amplifier.
Special mode: no press for
60 seconds
RAM-L exits the special
mode and turns off
Automatically happens if
user does not press the
power button
Table 2. Power button actions to activate testing modes
