Edificio Genebre. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
[email protected] - www.genebre.es
GENEBRE S.A.
FECHA DE REVISIÓN: 19/01/2021 NUMERO DE REVISIÓN: 2
9
WARNING
: Do not remove the selector lever securing cross head screw as this will allow
its internal mechanism to become loose and will cause irreparable damage to the
actuator’s gearbox. Removing this screw will invalidate the warranty.
When “MAN” function is selected:
•
The electronic system cuts the power to the motor after a few seconds.
•
The motor to output shaft drive is disconnected.
•
The desired position can be achieved by using the handwheel.
•
There are two ways to re-
activate the motor after being isolated whilst in “MAN”
position:
1.
With the actuator in ‘MAN’ function, using the handwheel/ handlever, turn
the actuator to one of the endpositions (open or closed). If the endposition
switch is activated the motor runs. Now switch the manual override from
“MAN” to “AUTO” . and the actuator is ready to operate automatically again.
2.
Switch from “MAN” mode to “AUTO”. Desactivate the supply voltage for a
few seconds which resets the actuator and it is then ready to operate
automatically again.
Automatic/manual
lever
Manual
Override
