Genebre Building. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
[email protected] - www.genebre.es
GENEBRE S.A.
UPDATE DATE: 27/05/2021 UPDATE NUMBER: 4
6
•
The positioner’s support is designed to be mounted on actuators with a shaft
height of H=20 or H=30, as well as fixing holes at 80 mm or 130 mm according
to Namur regulations.
6.2 Mounting of the Cam
Note: The positioner leaves the factory with the cam mounted on the shaft and the
indicator plate in the position “RA” (counter-clockwise/reverse acting).
In case you need to switch the direction (clockwise/direct acting) proceed as follows:
•
Lift the cover of the positioner.
•
Remove the clamping screw from the indicator plate and remove the plate.
•
Remove the clamping nut from the cam.
•
Remove the cam and turn with the side marked as “DA” facing up.
•
Mount the cam on the ledge of the output shaft.
•
Set the actuator on the initial position.
Attention: Do not supply air to the equipment during this operation. It
may be highly dangerous.
