SR418
SR418 User Manual
9000-0000-098 Revision 01
5 of 11
Genave Electronics
Product Overview
Basics
The SR418 Control consists of a Transmitter unit and a Receiver unit which communicate on a
frequency of 418MHz and have a range of up to 800 feet. When a button is pressed on the transmitter, a
signal is sent to the receiver which then activates the corresponding output associated with the button.
(ex. Button #2 is pressed on the transmitter, Output #2 activates on the receiver unit)
FCC Requirements
The transmitter has been pre-certified for FCC Part 15 and Industry Canada license-exempt RSS
standards for an intentional radiator. It has already been labeled in accordance with FCC, Industry
Canada and CE regulations. Note: The transmitter is not authorized for use in EUROPE. Please contact
Genave for use outside North America.
INSTRUCTIONS TO THE USER
This device complies with Part 15 of the FCC Rules and Industry Canada license- exempt RSS standard(s).
Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
The user is cautioned that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to operate this equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
