SR418
SR418 User Manual
9000-0000-098 Revision 01
9 of 11
Genave Electronics
MODE LED
CREATE button
Setting the Transmitter Address
The Long-Range Handheld Transmitter allows the selection of one of 16,777,216 unique
addresses. All transmitters are shipped with a unique address to avoid contention with other
units; however, the address can be changed.
To change the address: Use a paper clip to press the
CREATE
button through the hole in the back of
the case. An LED will light up in the
MODE
window, indicating that the address is being created. The
address is randomized for as long as the button is held down.
Release the button and the randomized address is
saved and the LED begins flashing to indicate that
Button Permissions may now be set.
Press each of the buttons on the keypad that the
transmitter is to send. Any buttons not pressed
during this step will be ignored by the transmitter
and
have no function.
Press the
CREATE
button again or wait 17
seconds for it the MODE window to time out.
The address and Button Permissions are now set.
The decoder needs to learn the address of the transmitter before it will accept its transmissions.
Please refer now to
“Pairing of TX to RX”
