ENC-3300-DTMF
Using the ENC-3300
The encoder should be placed on a flat surface.
Sending a signal or command
•
Make sure the encoder is powered and ready. Also make sure the two-way radio is turned on,
working and the correct channel is selected on the radio.
•
Firmly press then release the button on the ENC-3300 to initiate the transmission sequence. The
button should be pressed for at least 1/2 second or until the unit beeps. The red “Busy” indicator will
turn on.
•
If the button has been programmed to require a second press (Tap-2™) before sending the signal, a
15 second countdown timer will appear and the internal speaker will beep every second. The signal
will not be sent unless the button is pressed again before the timer expires.
•
The “Tx” indicator will turn on when the encoder begins generating the DTMF code string.
•
The LCD screen will indicate the progress and completion of the action.
•
After completion of the transmission, both the Busy and Tx indicators will turn off and you are free to
begin another activation. After a short period the encoder returns to its welcome screen if no other
buttons are pressed.
Stopping a transmission in progress
Press and release the
ESC
button to stop a transmission in progress. This will stop further signals or
actions, however it will not retrieve signals already sent.
Genave/NRC,Inc. 9000-0000-086 rev 4
Pg. 18
