Gemtek Systems P-380, Руководство пользователя

Страница: 43 / 67

Outdoor Router P-380 Users Guide
7 System Configuration Using Command Line Interface
7.1 Overview
The CLI (Command Line Interface) software is a configuration shell for the Operator Access Point (P-
380). Using the CLI, the operator can:
Configure all essential Access Point configuration settings;
View system, interface, network status, and network statistics;
Use the system tools, such as Site Survey.
In general, there are two ways to connect to the CLI:
Telnet
SSH client (encrypted)
These following sections describe the CLI command line interface used with telnet and the command
set available.
The commands and parameters shown in the CLI configuration will vary depending on
operating mode. The screenshots in this section just show examples, which may differ
from your display.
To get more information about the full range of commands and parameters please refer
to the CLI Configuration Commands and Parameters section.
7.2 Login
To access the P-380 via the CLI, open a command prompt and type
telnet 192.168.2.2
where 192.168.2.2 is your device’s IP address. CLI mode starts automatically. The login password is
the same as the HTML system’s administrator password.
Figure 44 – CLI Login Dialog
After successful login, the command prompt is displayed and the CLI is ready for commands. Press
‘?’ to get a list of available commands:
Note: The ? will not appear on the screen. In the same moment you are pressing this
character, the display changes to the desired help page.
Gemtek Systems Page 43