GEMMA TECHNICAL HELIOS STELLAR, Руководство пользователя

Страница: 11 / 76

11 | H E L I O S
A1 WEBBING HARDWARE FOR STELLAR
Hardware Usage Qty
Rubber Round Ring Inflator hose guide 1
Webbing rubber band Securing excess webbing 4
2” S/S Bent D-rings 2
2” S/S Straight/ standard D-rings Not including integrated D-rings 3
2” tri-glides 8
2” tri-glides 3 slots (chest strap tri-glide) Each end of the chest strap pre-installed 2
Plastic webbing clip Used for excess belt webbing 1
Helios Quick Pull webbing buckle Front adjustment 2
S/S Waist buckle

On the left shoulder webbing insert/loop a tri-glide with the
Rubber Round ring. Thread the webbing in the tri-glide as
per illustration. This rubber round ring is used to guide the
inflator corrugated hose.

Insert/ loop a tri-glide and a bent D-ring on both of the left
and right shoulder webbing. Make sure the curve of the
bent D-ring is pointing outward.

These upper-chest bent D-rings should be positioned so
you may comfortable attach and detach items using the
same side hand. (While folding your arms parallel to the
ground your thumb should fold around the center of the
bent D-ring when properly positioned)

Insert a webbing rubber band (snoopy loop) to the webbing

Thread the Chest Strap Tri-glide to the left and right
shoulder webbing. (The adjustable chest strap should face
outward)

Loop each end of shoulder webbing through the top slot of
the Quick pull webbing buckle. (See below illustration of the
quick pull)

Thread the remaining webbing back into the Chest strap tri-glide

Allow sufficient space between the Chest strap Tri-glide and the Quick pull webbing buckle to install
the shoulder pad Velcro tabs

Finally insert the excess webbing in the rubber band
Left
shoulder
Webbing Right
shoulder
Webbing
Quick Pull
Top slot
Quick Pull
Bottom slot