PAGE 04 - USER MANUAL
INSTALLER MANUAL - PAGE 05
INSTALLER MANUAL
5.0 - INSTALLATION OF SENSORS
To install the sensors on a metal bumper, you must use appropriate adapters (not
supplied).
Before drilling, inspect behind the bumper to check for any possible obstruction such as
iron struts and, in any case, be careful to avoid damaging parts behind the bumper.
!
!
6
6a
2
2
1
1
+
+
4 x
18
22
9
2
1
+
24
8
H
MAX
H = 500 mm
H = 650 mm
Choose the suitable type of
acket and mark the center of the holes to drill.
For brackets “6” drill holes with a 18mm diameter, for brackets “6a” drill holes with a 22mm
diameter and for brackets “8” and “9” drill holes with a 24mm diameter.
Sensors and plastic brackets can be painted to match the color of your bumpers.
plastic br
250
600
250
600
3.2 - REAR SENSORS
The rear sensors are activated when reverse gear is engaged; an audible signal will indicate the
sensors are active.
Detection of obstacles is signalled by the buzzer.
The tone of the buzzer indicates in which detection zone the obstacle is located.
The faster the beeping, the closer the obstacle..
By means of a specific connection, the system functioning can be inhibited in case of
towing.
4.0 - TROUBLESHOOTING GUIDE
4.1 - LOW POWER SUPPLY SIGNAL
4.2 - FAULTY SENSORS
If, when the control unit is turned on, the battery level is too low to guarantee the accuracy of the
system, the buzzer will almost immediately give out a deep warning tone for 5”.
This will inform the user that ALL the sensors are deactivated.
The driver will therefore know that he will have to do without the parking sensors.
If, when the control unit is turned on or the reverse gear is engaged, one of the sensors turns out to be
inoperative or not connected,an audio signal will sound for 3”.
If more than one sensor is inoperative, the number of the faulty sensors will be alternatively displayed
on the main control unit.
Sensor 1 inoperative.
Sensor 4 inoperative
One single faulty sensor alters the correct functioning of the whole parking
system.
Ice on sensors
Sensors mounted too low
Back part of sensors in contact with frame
Sensors detect external spare wheel
POSSIBLE CAUSE
Clean the sensors
Use the angle brackets (6a or 9) to tilt axe of sensors
upwards
Create a separation between the sensors and the vehicle
Modify the setting of parameter 10
SOLUTION
4.3 - OTHERS
If necessary, adjust the sensors sensitivity level (see chap. 8.0, Setting of parameter -
parameter 17).
H = 500 mm H = 650 mm
0°
-10°
9
8
6a
6
2
2
+10°
+0°
1
1
H = 350 mm
+10°
