PAGE 08 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 09
7.0 - CONNECTIONS TO ARM/DISARM THE SYSTEM
Alarm system 93 MHW can work either via CAN BUS or via the Gemini remote control (P/N 738W) as
described hereunder.
2
6.0 - VEHICLE CODE PROGRAMMING
The system must be configured according to the specific vehicle model on which it is to be installed.
To help you understand the coding procedure, here below is an example illustrating the configuration
procedure.
In this case the code used is 1-0-3 which hypothetically corresponds to a “FIAT XXXXX”.
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works properly.
If needed, disconnect the 8-pin connector and reconnect it after a few seconds.
10 F
1 SHORT PAUSE
3 FLASHES
1 FLASH +
1 SHORT PAUSE
When the last digit is entered, the alarm system “repeats” the entered code.
7.1 - OPERATION VIA CAN BUS
7.2 - OPERATION VIA GEMINI REMOTE CONTROL
In this case, arming/disarming and alarms are managed via the CAN BUS line. Only the alarm system
CAN BUS wires need to be connected to the vehicle CAN BUS wiring (see available diagrams in the
restricted area of our website:
).
This type of connection allows to arm/disarm the system and lock/unlock the vehicle doors via the
Gemini remote control (P/N 738W).
For vehicle specific information, s
in the restricted area of our
website:
).
www.gemini-alarm.com
www.gemini-alarm.com
ee available installation guidelines
A separate leaflet, included in the alarm packaging, lists all the available vehicles (codes
are updated at packaging time).
Up-to-date information on supported vehicle models can be found in the restricted area
of our website:
.
www.gemini-alarm.com
The alarm has an indicator LED that signals any wrong vehicle code inserted.
The code must range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times. In this case
there is no optical warning, the procedure is simply interrupted.
In either case, repeat the whole procedure.
!
!
Connect the wiring harness connectors to the corresponding alarm connectors.
Press and hold the button shown below until the LED lights up.
Release the button, the LED switches OFF.
The LED will start flashing after 3 to 4 seconds; count the flashes.
In this case press the button at the 1st flash which corresponds to number “1”.
After 4 seconds, the LED will flash for the 2nd time.
Press the button at the 10th flash which corresponds to “0”.
After 4 more seconds, the LED will flash for the 3rd and last time.
Press the button at the 3rd flash which corresponds to number “3”.
Press
Press
Press
1ST
FLASH
10TH
FLASH
3RD
FLASH
3-4 seconds
During an alarm event the system cannot be disarmed via the Gemini remote
control but only with the vehicle original remote control.