PAGE 16 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 17
To reset the system proceed as follows:
• Disconnect the alarm power supply.
• Short-circuit the RED and BLACK wires of the 2-pin LED connector.
• Power the system; 4 acoustic signals and 4 flashes of the turn indicators will confirm the operation.
• Remove the previously created short-circuit; the status LED will light up steady.
• Turn ignition key “ON”; reset is confirmed by an acoustic signal and the wailing of the siren for
approx. 3 sec.
• Turn ignition key “OFF”; the status LED will turn OFF. There are no acoustic signals.
This procedure will restore factory settings therefore any device that was previously
paired (ex. TAG ) will be cleared.
It
.
You will have to pair the devices all over again.
must therefore only be used in case of need, before programming the
system or learning the turn indicators flashes
!
12.
12.1
12.2
0 -
-
- SENSOR ADJUSTMENT
• Insert the WHITE connector in the “W” socket.
• Insert the RED connector in the “R” socket.
• Install
.
To check the sensitivity level proceed as follows:
• With the alarm system disarmed,
.
•
.
•
.
• During the arming delay
status LED will turn OFF to signal a presence.
• If the sensitivity level
.
ULTRASONIC VOLUMETRIC PROTECTION
CONNECTIONS AND POSITIONING
the ultrasonic sensors on the top part of the windshield internal pillars, away from the air vents
and point them towards the center of the rear window
roll down the front window approx. 20 cm
Set the trimmer to an intermediate position (medium sensitivity)
Close all doors, bonnet and boot and arm the system
introduce an object in the cabin through the window and move it around;
the
is too high or too low, readjust the trimmer and repeat the above procedure
CELL
CONNECTIONS
SENSITIVITY
ADJUSTMENT
14.0 - TECHNICAL SPECIFICATIONS
Power supply
Engine immobilizer relay contact capacity
Current absorption @ 12Vdc with system armed and LED flashing
Turn indicators relay contact capacity
Alarm cycle duration
Maximum positive current output with system armed (+A)
Maximum load of siren output
Working range temperature
12 Vdc
15mA
-30°C to +70°C
8A @ 20°C
30 sec.
8A @ 20°C
700mA
1A
13.0 - SYSTEM RESET
15.0 -
)
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.