6.0
932IT alarm system can operate in various modes according to the vehicle on which it is installed
and the available connections.
- CONNECTIONS TO ARM/DISARM THE SYSTEM
The
The alarm system can be managed via the vehicle CAN BUS line and operate in combination with the
CAN signals, with the turn indicators flashes and/or the door lock motor unit. The system
automatically manages the different arming/disarming signals.
If the turn indicators lock/unlock flashes are identical, also connect the door lock motors.
If the turn indicators flash when unlocking with the car mechanical key, do not make this
connection.
!
!
To arm/disarm the system, connect the WHITE-ORANGE wire to one of the turn indicator wires.
6.4 - COMBINATION CONNECTION
This type of connection allows the system to operate via the CAN line in combination with the turn
indicators or the door lock motor unit or both.
or the door lock motor unit or both.
The system automatically manages the different lock/unlock signals according to the selected
configuration and connections.
6.2 -
6.3
CONNECTIONS TO LOCKING MOTORS
CONNECTIONS TO TURN INDICATORS
System arming/disarming connections must be made to the vehicle door lock motor unit (invert polarity).
-
Select one of the arming modes and connections indicated hereunder (r
Arming via turn indicators flashes.
Arming via turn indicators flashes and locking motors
rming via turn indicators flashes, locking motors and
!
efer to the
.
Arming via CAN BUS.
Arming via door lock motor unit.
.
A
CAN BUS line.
!
!
!
!
vehicle specific
installation instructions available in the private area of our website)
6.1 -
System arming/disarming and alarms are managed via CAN therefore only connect the alarm system
CAN wires to the vehicle CAN lines (
www.gemini-alarm.com).
CONNECTIONS AND OPERATION VIA CAN BUS LINE
see available installation guidelines in the private area of our
website:
PAGE 10 - INSTALLER MANUAL
7.0 -
The system must be configured based on the vehicle model on which it is installed.
Here below is an example illustrating the configuration procedure. In this case the code to be entered
is 1-0-3
“FIAT XXXXX”.
VEHICLE CODE PROGRAMMING
which hypothetically corresponds to a
A separate leaflet, included in the alarm packaging, lists the available vehicles (codes
are updated at packaging time).
Up-to-date information on supported vehicle models can be found in the private area of
our website: www.gemini-alarm.com.
The system has an indicator LED that signals any wrong vehicle code inserted.
The code must range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there are no optical warnings, the procedure is simply interrupted.
In either case, repeat the entire procedure.
!
!
Connect the wiring harness connectors to the corresponding alarm connectors.
Press and hold the button shown below until the LED lights up.
Release the button, the LED will go out.
After 3 to 4 seconds, the LED will start flashing.
“1”.
Press the button at the first flash which corresponds to number
After another 4 seconds, the LED will start flashing again.
“0”.
Press the button at the 10th flash which corresponds to
After 4 more seconds, the LED will flash for the third and last time.
“3”.
Press the button at the 3rd flash which corresponds to number
Press
Press
Press
1st
FLASH
10th
FLASH
3rd
FLASH
3-4 seconds
INSTALLER MANUAL - PAGE 11